Honeywell INTELLIKNIGHT 5820XL User Manual

Page 106

IntelliKnight 5820XL Installation Manual

6-4

151209

- Accept Configuration

1. If you are ready to make the JumpStart configuration permanent,

select .

2. The system will ask you if the installation contains any addressable

duct detectors. If there are none, select

for No and skip to Step

8. If the system contains duct detectors, select

for Yes and con-

tinue with Step 3.

3. From the list that displays, select the 5815XL device that contains

the duct detectors.

4. The first photoelectric or ionization detector on the system will dis-

play. Select

for DUCT and

for NonDUCT.

5. Press

to select the next detector. Select

for DUCT and

for NonDUCT. Continue until all duct detectors have been selected.

(Note: You can move backwards through the list with

6. When you reach the last detector on this device, press

7. The system will ask you if there are more duct detectors in the sys-

tem. If there are, select

for Yes and repeat from Step 3. If there

are no more duct detectors, select

for No and continue with

Step 8.

8. The system will restart in 10 seconds. You can press

to restart

immediately.

9. After the system resets, it will use the new JumpStart configuration.

- Enter Programming

If you want to go directly to Program Mode to configure any devices,

press

. The Programming Menu appears and you can begin

programming.