Honeywell INTELLIKNIGHT 5820XL - Manual (Page 186)

IntelliKnight 5820XL Installation Manual
8-12 151209
Note: Detector status can also be viewed and printed using the 5660 SKSS or 5670 SKSS (facility mon-
itoring only).
8.6 Operation Mode Behavior
The control panel can be in one of seven conditions at any given moment: Normal,
Alarm, Prealarm, Supervisory, Trouble, Silenced, and Reset. Table 8-1 describes the
behavior of the panel in each of these modes.
= Print Detector
Status
Prints the current status of all detectors in the system. This is a method for finding out if
any detectors are out of NFPA compliance or any detectors need maintenance (are
approaching an out of compliance condition).
Sample Detector
Status Print-Out
Table 8-1: Operation Mode Behavior
Operation
Mode
Occurs
When
System Behavior In This Mode You Can
Normal No alarm or
trouble
condition
exists and
menus are
not in use. SYSTEM POWER LED is on.
The All Systems Normal display indicates that
the system is in normal mode.
The current date and time display on the last
line of the LCD.
Enter the appropriate code to activate the User
or Installer Menu, or rotate the key to activate
the User Menu.