Honeywell INTELLIKNIGHT 5820XL User Manual
Page 45
Control Panel Installation
151209
4-5
3. Run extended battery cable from control panel cabinet through conduit to RBB
Figure 4-5 Battery Connections in the RBB Cabinet
Note: Figure 4-5 is an example of how the wire connections can be routed. However, any other cabinet
knock-outs (on either the main control panel or the RBB cabinet), that are not previously being
used may be utilized to connect conduit between the two cabinets.
4. Connect battery leads to the backup battery terminals. See Figure 4-5.
•
Observe the proper polarity to prevent damage to the batteries or the control
panel.
5. Insert the RBB cover screws into the cover mounting holes. See Figure 4-5.
•
Screw the cover screw 3/4 of the way into the cover mounting hole.
6. Align the cover plate mounting keyhole over the cover mounting screws. See Fig-
Figure 4-6 Cover Plate Mounting Keyholes and Cover Mounting Screws Alignment
7. Slide the cover into place and tighten the cover mounting screws. See Figure 4-6
Conduit
Conduit
Coupler
+
+
-
-
RBB Cabinet
Cover Screws
RBB Cabinet
Cover Screws
Cover Plate
Mounting Keyholes