Emerson Process Management ROSEMOUNT 5300 - Manual (Page 122)

Reference Manual
00809-0100-4530, Rev BA
July 2009
Rosemount 5300 Series
6-2
VIEWING
MEASUREMENT DATA
Using the Display Panel The Rosemount 5300 transmitter uses an optional Display Panel for
presentation of measurement data. When the transmitter is switched on, the
Display Panel presents information such as transmitter model, measurement
frequency, software version, communication type (HART, FF), serial number,
HART identification tag, setting of write protection switch, and Analog Output
settings.
When the transmitter is up and running, the Display Panel presents Level,
Signal Amplitude, Volume, and other measurement data depending on the
Display Panel configuration (see “Specifying Display Panel Variables” on
page 6-3). The available LCD parameters are listed in Table 6-1 on page 6-6.
The display has two rows, the upper row shows the measurement value and
the lower row shows the parameter name and measurement unit. It toggles
between the different measurement values every 2 seconds. The lower row
toggles between parameter name and measurement unit each second.
Variables to be presented are configurable by using a 375 Handheld
Communicator, AMS, DeltaV or the Rosemount Radar Master software.
Figure 6-1. The 5300 Display
Panel.
Error messages are listed in section “LCD Error Messages” on page 7-42.
3
Measurement value
Toggling between
measurement
parameter and
measurement unit