HEIDENHAIN TNC 335 Technical Manual - Manual (Page 579)

12-8
TNC 360 Subject Index 8/95
positioning error.................................................................................................................. 4-70; 4-71
Positioning module ............................................................................................................. 3-2
Positioning window ............................................................................................................ 4-73
Potential steps.................................................................................................................... 4-58
Power consumption ........................................................................................................... 2-5
Power supply...................................................................................................................... 3-14
PROCESSOR CHECK ERROR M ....................................................................................... 3-15
Program, end of.................................................................................................................. 4-136
Programming station .......................................................................................................... 4-135
Pull Stack (PLL)................................................................................................................. 7-91
Pull Stack (PLW) ............................................................................................................... 7-91
Pull Stack (PL)..................................................................................................................... 7-90
Q
Q parameters, overwriting ................................................................................................. 4-136
R
Radial acceleration.............................................................................................................. 4-67
RAM operation ................................................................................................................... 7-21
RAM test ............................................................................................................................ 4-136
Ramp slope for S-analogue voltage .................................................................................... 4-82
Rapid traverse..................................................................................................................... 4-55
Reference end-position ...................................................................................................... 4-39; 4-50
Reference marks ................................................................................................................ 4-37
reference marks, passing over ........................................................................................... 4-39
Reference point .................................................................................................................. 4-110
RELAY EXT. DC VOLTAGE MISSING................................................................................. 4-109
REMAINDER (MOD) ........................................................................................................ 7-61
REMAINDER [ ] (MOD[ ]) ................................................................................................. 7-75
RESET (R) ......................................................................................................................... 7-40
RESET NOT (RN) .............................................................................................................. 7-42
Residual voltage ................................................................................................................. 4-71
Rigid tapping....................................................................................................................... 4-104
Rigid tapping, Acceleration ramp for .................................................................................. 4-105
Rotary axes......................................................................................................................... 4-115
Rotary axis, display mode for ............................................................................................. 4-115
Rotational axis .................................................................................................................... 4-12
RS-232-C/V.24 .................................................................................................................... 3-32
Run duration timers ............................................................................................................ 4-118
Run duration, display of ...................................................................................................... 4-118
Run-in behavior................................................................................................................... 4-62
S
S code................................................................................................................................. 4-92
Sag...................................................................................................................................... 4-25
Scale datum point............................................................................................................... 4-110
Scaling factor ...................................................................................................................... 4-131
Scanning range ................................................................................................................... 4-158
S-code table........................................................................................................................ 4-93
Secondary linear axis .......................................................................................................... 4-13
Sequence for traversing reference marks .......................................................................... 4-49
Servo accuracy ................................................................................................................... 4-57