HEIDENHAIN TNC 335 Technical Manual - Manual (Page 303)

4-206
TNC 360 15 Tool Changer 8/95
N
→
M: Manual tool follows Normal tool
With this toolchange sequence two pocket numbers (or tool numbers) must be transferred in
succession. M2093 indicates that another TOOL CALL strobe (M2046) follows.
Irrespective of marker M2600, the pocket number of the old tool and tool number 0 are transferred
first. Tool number 0 tells the PLC to clear the spindle. After acknowledging with M2483, pocket
number 255 and the tool number of the called tool are transferred. Pocket number 255 tells the PLC
that there is no pocket in the tool magazine for the called tool.
0
0
0
0
0
0
0
0
3RFNHW1R>1@3RFNHW1R :
7RRO1R7RRO1R>0@
: