HEIDENHAIN TNC 335 Technical Manual - Manual (Page 353)

4/96
TNC 360 3 List of Machine Parameters 5-9
Machine
parameter Function and input Reaction /
CN 123 Page
MP1110 Standstill monitoring
Input range: 0.001 to 30 [mm] 4-72
MP1140 Movement monitoring
Input value: 0.03 to 10 [V] 4-71
MP1150 Delay time before switching off the residual
voltage on error message "Position error"
Input value: 0 to 65.535 [s] 4-70
MP1220 Automatic cyclical offset adjustment
Input value 0 to 65 536 [s]
0 = no automatic adjustment
4-63
MP1320 Direction for traversing the reference marks
Input range: 0 to 15
Bit 0 Axis X +0 = positive
+1 = negative
Bit 1 Axis Y +0 = positive
+2 = negative
Bit 2 Axis Z +0 = positive
+4 = negative
Bit 3 4th axis +0 = positive
+8 = negative
4-48
MP1330.0
to
MP1330.3 Feed rate for traversing the reference marks
Input range: 80 to 30 000 [mm/min]
4-48
MP1331.0
to
MP1331.3 Feed rate for leaving the reference end position
(only for rotary encoders MP1350 = 2)
Input range: 80 to 500 [mm/min] 4-48
MP1340.0
to
MP1340.3 Sequence for traversing reference marks
Input range: 0 to 4
0 = no evaluation of the reference marks
1 = axis X
2 = axis Y
3 = axis Z
4 = 4th axis
REF 4-48
MP1350.0
to
MP1350.3 Type of reference mark approach
Input range: 0 to 3
0 = measuring system with distance-coded
reference marks
1 = measuring system with one reference mark
2 = special sequence (linear measurement
via rotary encoder)
3 = measuring system with distance-coded
reference marks; after REF end position
traverse direction is changed
REF 4-49