HEIDENHAIN TNC 335 Technical Manual - Manual (Page 363)

4/96
TNC 360 3 List of Machine Parameters 5-19
Machine
parameter Function and input Reaction /
CN 123 Page
MP7260 Number of tools in the tool table
Input: 0 to 99
0 = No central tool file
1 - 99 number of tools, tool file is active CN 123
RESET 4-196
MP7261 Number of pockets in the tool magazine
Input: 0 to 99 CN123
RESET 4-
214
MP7264 Number of pockets reserved next to special tool
Input: 1 to 3 CN 123
RESET 4-197
MP7270 Display of the feed rates in manual operating
modes (Manual operation, Electronic handwheel)
Input: 0 or 1
Bit 0 = 0 Display of the axis feed rate only when
an axis direction key is pressed
Bit 0 = 1 Display of the axis feed rate before
operating an axis-direction key (smallest
value from MP1020.X for all axes)
Bit 1 = 1 Abortion after NC stop in manual
operating mode (control-in-operation
symbol off)
CN 123 4-116
MP7274 Expanded spindle display
Input: 0 to 3
Bit 0
Display of current gear range
+0 No display
+1 Display
Bit 1 Display of spindle power
+0 Acquisition via analog input
+2 Acquisition via PLC word W600
4-120
MP7275 Reference value of displayed spindle power for
acquisition via analog input
Input: 0 to 4.999 [V]
for acquisition via word W600
Input: 0 to 43 690
Input value is equivalent to 100%
4-120
MP7280 Decimal sign
Input: 0 or 1
0 = Decimal comma
1 = Decimal point
CN 123 4-134
MP7285 Calculation of the tool length for the position
display of the tool axis
Input: 0 or 1
0 = Tool length is not calculated
1 = Tool length is calculated
CN 123 4-113