HEIDENHAIN TNC 335 Technical Manual - Manual (Page 464)

8/95
TNC 360 3 Commands 7-85
3.10 Bit Commands
3.10.1 BIT SET (BS) BS
Abbreviation for PLC Editor: BS (BIT SET)
Byte/Word/Double Constant
Execution time [µs] 2.0 to 2.4 2.0
Number of bytes 6 8
Operands: B, W, D, K
Operation:
With this command, each bit in the Accumulator can be acted on. The addressed bit is set to "1"
through the use of the BS command. The selection (addressing) of the corresponding bit is derived
from the content of the specified Operand or a Constant. In the bit numbering, bit 0 corresponds to
the LSB and bit 31 the MSB. For operand contents larger than 32, the operand value Modulo 32 is
used, i.e. the integer remainder from the division (operand value)/32.
Example:
Load Doubleword D8 in the Accumulator, set the bit 0 of the Accumulator to "1" and store the result
in Doubleword D12.
Initial state: Doubleword D8 = 3E 80 (hex)
Doubleword D12 = ?
Accumulator and operand contents are shown here in hexadecimal notation.
Line Instruction Accumulator Content Operand Content
xx xx xx xx
1 L D8 00 00 3E 80 00 00 3E 80
2 BS K+0 00 00 3E 81
3 = D12 00 00 3E 81 00 00 3E 81
Line 1: Load Doubleword D8 into the Accumulator.
Line 2: The bit specified in the operand is set to 1.
Line 3: The result is stored in Doubleword D12.