HEIDENHAIN TNC 335 Technical Manual - Manual (Page 524)

8/95
TNC 360 2 TNC data interfaces 8-17
Example: protocol for dialog program:
.. 50 times
0 BEGIN PGM 1 MM
1st program block
1 TOOL DEF 1 L+0 R+3 2nd program block
.
.
.
26 END PGM 1 MM
Program end
Close data transfer menu
Example of software handshake:
Peripheral unit Transmission path
Receiving buffer full
Receiving buffer again
ready to accept data
12 Z+Z FMAX
13 Z–10 F100 M03
TNC
.
.
.
.
.
.
Hardware handshake (see Section "Freely configurable interfaces").
2.4.2 Data transfer with Block Check Character (BCC)
This protocol, specific to HEIDENHAIN, works with different control characters and with additional
data checking when transmitting.
In the freely configurable operating modes (EXT), the following control characters - ,
, , , , , - can be defined as arbitrary ASCII characters
(see Section "Freely configurable interfaces").