HEIDENHAIN TNC 335 Technical Manual - Manual (Page 378)

4/96
TNC 360 2 List of Words 6-9
2 List of Words
Word
Words Function Page
W256 G code for S analogue 4-86
W258 S code 4-91
W260 Code for M function 4-138
W262 Pocket number when MP7480 = 3
Tool number when MP7480 = 1 or 2 4-199
W264 Tool number when MP7480 = 3 4-199
W272 Operating mode
0 = Programming and editing
1 = Manual operation
2 = Electronic handwheel
3 = Positioning with manual entry
4 = Program run/single block
5 = Program run/full sequence
6 = Test run
7 = Pass over reference point 4-141
W274 Key code for the operated, inhibited key, Signal via M2182 4-141
D276 Code number entered in MOD mode –
D280 1st value FN19 –
D284 2nd value FN19 –
W320 Nominal spindle speed 4-80
W322 Actual spindle speed 4-80
D356 Programmed spindle speed (NC
→
PLC) 4-80
D360 Programmed feed rate (NC
→
PLC) –
D388 Current feed rate (NC
→
PLC) –
W392 Analog voltage of the analog input (0 to 5 V) –
W492 % factor – spindle override (NC
→
PLC) 4-84
W494 % factor – feed rate override (NC
→
PLC) 4-116
W512 T code –
W514 P code –
W516 Word with multiple function
Key code for simulation of TNC keys
Activate with M2813
Number of the Q parameter to be overwritten (Q100 to Q107 = 0 to 7) 4-135
W522 Monitoring functions suppressed if PLC
input from MP4130 is activated 4-68
D528 Value to be transferred to the Q parameter
Datum correction for X axis
Position of X axis [1/1000 mm] 4-135
4-194
4-32
D532 Datum correction for Y axis
Position Y axis 4-194
4-32
D536 Datum correction for Z axis
Position Z axis 4-194
4-32
D540 Datum correction for 4th axis
Position 4th axis 4-194
4-32
W560 Feed rate X axis [mm/min] 4-33
W562 Feed rate Y axis 4-33
W564 Feed rate Z axis 4-33