HEIDENHAIN TNC 335 Technical Manual - Manual (Page 383)

7-4
TNC 360 8/95
4.9.3 Module 9102: Interface status 7-111
4.9.4 Module 9105: Transmit binary data via data interface 7-112
4.9.5 Module 9106: Receive binary data via data interface 7-113
4.9.6 Module 9120: Position an auxiliary axis 7-114
4.9.7 Module 9121: Stop an auxiliary axis 7-115
4.9.8 Module 9122: Poll the status of an auxiliary axis 7-115
4.9.9 Module 9123: Traverse the reference point of an auxiliary axis 7-116
4.9.10 Module 9124: Override for PLC axis 7-117
4.9.11 Module 9125: Run an NC block 7-118
5 Compatibility with TNC 355 7-121
5.1 PLC Program Conversion 7-122
5.2 Compatibility Markers 7-123
5.3 Incompatibility 7-125
5.3.1 PLC Macros 7-125
5.3.2 Non-implemented markers 7-128
5.3.3 PLC Cycle Time 7-128