HEIDENHAIN TNC 335 Technical Manual - Manual (Page 29)

8/95
TNC 360 3 Software 2-7
3.1.1. Software and hardware versions
HEIDENHAIN has manufactured several different hardware versions of the logic units LE 360 and LE
360 C. The following table shows which software is compatible with which hardware version:
Id.-Nr. LE 360 Id.-Nr. LE 360 C
Software Type
/Version
258 991 99 264 660 99 264 085 99 270 641 39
(BE 212) 270 642 39
(BF 110)
259 90x 02 to 05 02 to 05 02 to 05 06 -
260 02x (1-MB
EPROM) - - from 07 from 07 from 07
280 49x (2-MB
EPROM) - - - from 08 from 08
Only the software types 260 02 and 280 49 will continue to be developed.
Software Releases
HEIDENHAIN releases new versions of NC software in irregular intervals.
NC Software Version Release
259 90x 02 1/91 (Introduction)
259 90x 03 7/91
259 90x 04 3/92
259 90x 05 3/92
259 90x 06 7/92
260 02x 04 3/92 (Introduction)
260 02x 05 3/92
260 02x 06 7/92
260 02x 07 10/92
260 02x 08 7/93
260 02x 09 9/93
260 02x 10 Never released
260 02x 11 1/94
260 02x 12 2/94
260 02x 13 6/94
260 02x 14 6/94
260 02x 15 7/94
260 02x 16 3/95
280 49x 08 7/93 (Introduction)
280 49x 09 9/93
280 49x 10 Never released
280 49x 11 1/94
280 49x 12 2/94
280 49x 13 6/94
280 49x 14 6/94
280 49x 15 7/94
280 49x 16 3/95