HEIDENHAIN TNC 335 Technical Manual - Manual (Page 370)

4/96
TNC 360 1 List of Markers 6-1
1 List of Markers
The markers listed in italics have been retained to insure compatibility with the TNC 355. It is
recommended, however, that these functions be activated through the new word functions.
Marker Function Set Reset Page
M2000 Axis enable X NC PLC 4-74
M2001 Axis enable Y NC PLC 4-74
M2002 Axis enable Z NC PLC 4-74
M2003 Axis enable 4 NC PLC 4-74
M2004 S-analogue voltage not on ramp NC NC 4-82
M2005 S-analogue voltage = 0 V NC NC 4-82
M2007 Spindle in position NC NC 4-95
M2008 X axis in position NC NC 4-75
M2009 Y axis in position NC NC 4-75
M2010 Z axis in position NC NC 4-75
M2011 4th axis in position NC NC 4-75
M2012 Lubrication pulse X axis, since value of MP4060.0
was exceeded NC NC 4-18
M2013 Lubrication pulse Y axis, since value of MP4060.1
was exceeded NC NC 4-18
M2014 Lubrication pulse Z axis, since value of MP4060.2
was exceeded NC NC 4-18
M2015 Lubrication pulse 4th axis, since value of MP4060.3
was exceeded NC NC 4-18
M2022 Touch probe not ready (no standby signal at connector X12) NC NC 4-153
M2023 Stylus deflected before start of probing cycle NC NC 4-153
M2025 Stylus deflected (probing sequence is executed) NC PLC 4-153
M2026 Probe operation ended or interrupted NC NC 4-153
M2027 Battery voltage too low (battery warning on connector X12);
evaluated only during the probe operation NC NC 4-153
M2032 T Code 1st bit (lsb) NC NC 7-123
M2033 T Code 2nd bit NC NC 7-123
M2034 T Code 3rd bit NC NC 7-123
M2035 T Code 4th bit NC NC 7-123
M2036 T Code 5th bit NC NC 7-123
M2037 T Code 6th bit NC NC 7-123
M2038 T Code 7th bit NC NC 7-123
M2039 T Code 8th bit (msb) NC NC 7-123
M2040 The control functions as point-to-point and straight-cut control NC NC 4-246
M2041 Basic language (English) is selected NC NC 4-134
M2042 Analogue output of the spindle speed NC NC 4-80
M2043 Change signal for gear code NC NC 4-86
M2044 Change signal for S code NC NC 4-91
M2045 Change signal for M function NC NC 4-138