HEIDENHAIN TNC 335 Technical Manual - Manual (Page 51)

8/95
TNC 360 6 Nominal Value Output 3-23
6 Nominal Value Output
The HEIDENHAIN contouring controls control the position loop servo with a nominal value potential
of
±
10 volts.
Maximum loading of the nominal value outputs: 2 mA
Maximum load capacitance: 2 nF
6.1 Connector assignment X8
Nominal value output 1
Analog input
Nominal value output 2
do not use
Nominal value output 3
do not use
Nominal value output 4
Nominal value output S axis
0V Nominal value output 1
Analog input
0V Nominal value output 2
do not use
0V Nominal value output 3
0V Nominal value output 4
0V Nominal value output S axis 1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
B R O W N
Y E L L O W
R E D / B L U E
P I N K
G R A Y / P I N K
R E D
V I O L E T
W H I T E
G R E E N
G R A Y
B L U E
B L A C K
max. 20 m
Id.-Nr. 244 006..
X8 Nominal value output
•
The interface complies with the recommendations in VDE 0160, 5. 88 for separation from
line power.
6.2 Connecting cable
HEIDENHAIN offers a connecting cable with a connector at one end (Id.-Nr. 244 006 ..).
The connecting cable to the nominal value outputs may not have more than one intermediate
terminal clamp. The clamp must be made in an earthed connection box. This is necessary when the
cable must branch to physically separate servo inputs. It is only possible to earth the screening of
the servo leads in this way. If required, suitable connection boxes are available from HEIDENHAIN
with the Id.-Nr. 251 249 01.
Connection box