HEIDENHAIN TNC 335 Technical Manual - Manual (Page 369)

4/96
TNC 360 3 List of Machine Parameters 5-25
Machine
parameter Function and input Reaction
/ CN 123 Page
MP7650 Count direction for handwheel
Input: 0 or 1
0 = Positive count direction
1 = Negative count direction
4-167
MP7660 Threshold sensitivity for electronic handwheel
Input value: 0 to 65 535 [increments] 4-167
MP7670 Minimum interpolation factor for handwheel
Input range: 0 to 10 4-167
MP7670
MP7670.0
MP7670.1
MP7670.2
Interpolation factor for handwheel HR410
Input: 0 to 10
Interpolation factor at low speed
Interpolation factor at medium speed
Interpolation factor at high speed
MP7671
MP7671.0
MP7671.1
MP7671.2
Manual feed rate in "handwheel" operation mode
with HR 410
Input: 0 to 1000 [% to MP1020]
Low speed
Medium speed
High speed
MP7680 Memory function for axis-direction keys
0 = not stored
1 = stored
4-149
MP7690 Memory test at switch-on
Input range: 0 to 3
Bit 0 RAM test
+ 0 = Memory test at switch-on
+ 1 = No memory test at switch-on
Bit 1 EPROM test
+ 0 = Memory test at switch-on
+ 2 = No memory test at switch-on
4-135