HEIDENHAIN TNC 335 Technical Manual - Manual (Page 576)

8/95
TNC 360 Subject Index 12-5
Interface RS-232-C/V.24 ..................................................................................................... 8-10
Interpolation factor ............................................................................................................. 4-7; 5-6
ISO programs ..................................................................................................................... 4-133
J
Jump Commands ............................................................................................................... 7-94
Jump if Logic Accumulator = 0 (JPF) ................................................................................ 7-94
Jump if Logic Accumulator = 1 (JPT) ................................................................................. 7-94
Jump Label (LBL).............................................................................................................. 7-98
K
Key code............................................................................................................................. 4-141
Key simulation .................................................................................................................... 4-141
Kink point............................................................................................................................ 4-59
kv factor.............................................................................................................................. 4-55; 4-63
L
Lag monitoring.................................................................................................................... 4-70
Lead-screw pitch error........................................................................................................ 4-25
LESS THAN (<) ................................................................................................................... 7-64
LESS THAN [ ] (<[ ]) .......................................................................................................... 7-78
LESS THAN OR EQUAL TO (<=) ..................................................................................... 7-66
LESS THAN OR EQUAL TO [ ] (<=[ ]) .............................................................................. 7-78
Linear axis-error compensation .......................................................................................... 4-24
Linear encoders .................................................................................................................. 3-19
Linear measurement .......................................................................................................... 4-6
LOAD (L)........................................................................................................................... 7-27
LOAD BYTE (LB)............................................................................................................... 7-32
Load command................................................................................................................... 7-27
LOAD DOUBLEWORD....................................................................................................... 7-32
LOAD NOT (LN)................................................................................................................ 7-29
Load Stack (PS)................................................................................................................. 7-89
Load Stack (PSL)............................................................................................................... 7-90
Load Stack (PSW) ............................................................................................................. 7-91
LOAD TWO'S COMPLEMENT (L–) .................................................................................. 7-31
LOAD WORD (LW)........................................................................................................... 7-32
Logic Gates......................................................................................................................... 7-44
Logic unit ............................................................................................................................ 3-4
Lubrication pulse ................................................................................................................ 4-19
M
M function, acknowledgment of ........................................................................................ 4-138
M functions ........................................................................................................................ 4-118; 4-137
Machine axes ..................................................................................................................... 4-6
Machine control panel ........................................................................................................ 3-53; 4-149
Machine datum................................................................................................................... 4-50; 4-110
Machine parameters .......................................................................................................... 5-3; 5-4
Manual feed........................................................................................................................ 4-57
Meander ............................................................................................................................. 4-158
Measuring system monitoring .......................................................................................... 4-9
Measuring systems ............................................................................................................ 3-19; 4-6
Mechanical defects ............................................................................................................ 4-22