HEIDENHAIN TNC 335 Technical Manual - Manual (Page 30)

2-8
TNC 360 3 Software 8/95
3.1.2 Software option
HEIDENHAIN offers the "Digitizing with TS 120" function as a software option (see Chapter "Machine
integration"). An additional software protection module is installed in controls supplied with this
software option. The Id.-Nr. of the LE 360 logic unit has the variant xxx xxx 79, while the LE 360 has
xxx xxx 34. If the software module is installed, the option number 262 351 01 is indicated on the
screen under the NC and PLC software numbers.
The “Digitizing with TS 120“ software option can be retrofitted. The kit is available under Id. Nr.
265 310 01.
The kit contains:
Software module (EPROM Id.-Nr. 262 351 01)
Printed circuit board
Sponge rubber
ID label
Mounting Instructions
3.2 PLC Software
The PLC software is produced by the manufacturer of the machine. Either HEIDENHAIN or the
manufacturer of the machine can store this software in EPROMs. HEIDENHAIN assigns PLC
software numbers to the machine manufacturers on request. HEIDENHAIN can archive the specific
PLC programs in a data bank, so that the installation of the correct PLC program is assured if a
control has to be exchanged.