HEIDENHAIN TNC 335 Technical Manual - Manual (Page 340)

8/95
TNC 360 16 Commissioning and Start-up Procedure 4-243
16.3.9 Adjust the offset
The rough offset adjustment has already been carried out on the servo amplifier. A fine offset
adjustment can be performed with the offset adjustment possibility described in Section "Servo
positioning".
16.3.10 Adjustment of the monitoring functions
The following entry values are recommended for the monitoring functions (see Section "Servo
positioning"):
Machine parameter Function Entry value
MP1710 Position monitoring 1.2
×
lag in rapid traverse
MP1720 Position monitoring (EMERGENCY STOP) 1.4
×
lag in rapid traverse
MP1410 Position monitoring 0.5 [mm]
MP1420 Position monitoring (EMERGENCY STOP) 10 [mm]
MP1140 Movement monitoring 0.5 [V]
MP1030 Positioning window 0.01 [mm]
MP1110 Standstill monitoring 0.2 [mm]
If the drives of the machine permit narrower limits, these may be entered.