HEIDENHAIN TNC 335 Technical Manual - Manual (Page 230)

8/95
TNC 360 6 Display and Operation 4-133
If a User parameter is selected by the operator, a dialog appears on the screen. Machine parameter
MP7340.x determines which dialog should be displayed.
The dialog is taken from the PLC error file (input 0 to 99) or from the dialog file (100 to 199).
MP7330 Determination of the User Parameters
Input range: 0 to 9999.00 (No. of the desired machine parameter).
MP7330.0 User parameter 0
MP7330.1 User parameter 1
. .
. .
MP7330.14 User parameter 14
MP7330.15 User parameter 15
MP7340 Dialogs for User Parameters
Input range:0 to 199 (line number of the PLC dialog)
MP7340.0 Dialog for User parameter 0
MP7340.1 Dialog for User parameter 1
. .
. .
MP7340.14 Dialog for User parameter 14
MP7340.15 Dialog for User parameter 15
6.9 Code numbers
The MOD functions can be used to enter code numbers for the control. These code numbers can be
used to activate certain control functions.
The following code numbers have a fixed meaning:
Code number Function
95 148 Select machine parameter list
807 667 Select PLC mode
105 296 Correction tables for the nonlinear axis-error compensation
86 357 Remove program protection
75 368 Automatic offset adjustment
123 Select the user-available list of machine parameters
531 210 Erase markers M1000 to M2000 and Byte 0 to Byte 127
Special function:
Switch-on the control while pressing the MOD key, then enter the code number.
The entire contents of the RAM memory (MPs, NC programs, PLC programs, all
markers, all bytes) are erased.
857 282 Clock displays