HEIDENHAIN TNC 335 Technical Manual - Manual (Page 557)

8/95 TNC 360 1 Introduction 9-5
MP7240 Inhibit program input for [Program number] = [OEM-cycle number in
EPROM].
Input value 0 or 1
0 = inhibit
1 = not inhibit
MP7250 Difference between Q-parameter number for "CALL-active" and "DEF-active"
block in OEM cycles
Input range: 0 to 50
MP7251 Number of global Q parameters transferred from OEM-cycle to calling
program.
Input range: 0 to 100
OEM cycles stored in the PLC EPROM can be inhibited in the PLC program via flags M2240 to
M2271. Inhibited cycles cannot be defined in NC programs.
If programs with definitions of inhibited or non-existent OEM cycles are transferred to the control
unit, an error message "PGM 999999.. UNAVAILABLE" is generated during program call. The
program cannot be run.
Flag Function Set Reset
M2240 Inhibit OEM-cycle 68 PLC PLC
M2241 Inhibit OEM-cycle 69 PLC PLC
M2242 Inhibit OEM-cycle 70 PLC PLC
. .
. .
. .
M2271 Inhibit OEM-cycle 99 PLC PLC