HEIDENHAIN TNC 335 Technical Manual - Manual (Page 223)

4-126
TNC 360 6 Display and Operation 8/95
6.6 Cycles
The HEIDENHAIN contouring controls permit calling HEIDENHAIN standard cycles within the NC
program (e.g.. pecking, tapping, pocket milling etc.).
In addition, the machine tool builder can program manufacturer cycles and store them in the control
(see chapter "OEM cycles"). The sequence of some cycles can be altered by machine parameters
and PLC markers.
The description of the "Tapping" and "Spindle orientation" cycles can be found in the section
"Spindle."
6.6.1 Cycle inhibit
Machine parameter MP7245 can be used to selectively inhibit the HEIDENHAIN standard cycles.
MP7245.0 Inhibit the HEIDENHAIN Cycles 1 to 15
Input range: 0 to 65 534
Bit 1 Cycle 1 + 0 = enable
+ 2 = inhibit
Bit 2 Cycle 2 + 0 = enable
+ 4 = inhibit
Bit 3 Cycle 3 + 0 = enable
+ 8 = inhibit
Bit 4 Cycle 4 + 0 = enable
+ 16 = inhibit
Bit 5 Cycle 5 + 0 = enable
+ 32 = inhibit
Bit 6 Cycle 6 + 0 = enable
+ 64 = inhibit
Bit 7 Cycle 7 + 0 = enable
+ 128 = inhibit
Bit 8 Cycle 8 + 0 = enable
+ 256 = inhibit
Bit 9 Cycle 9 + 0 = enable
+ 512 = inhibit
Bit 10 Cycle 10 + 0 = enable
+ 1024 = inhibit
Bit 11 Cycle 11 + 0 = enable
+ 2048 = inhibit
Bit 12 Cycle 12 + 0 = enable
+ 4096 = inhibit
Bit 13 Cycle 13 + 0 = enable
+ 8192 = inhibit
Bit 14 Cycle 14 + 0 = enable
+ 16 384 = inhibit
Bit 15 Cycle 15 + 0 = enable
+ 32 768 = inhibit