HEIDENHAIN TNC 335 Technical Manual - Manual (Page 362)

5-18
TNC 360 3 List of Machine Parameters 4/96
Machine
parameter Function and input Reaction /
CN 123 Page
MP7215 Contouring control or point-to-point and straight-cut
control
Input range 0 to 3
0 = Contouring control (TNC 360)
1 = Point-to-point and straight cut (TNC 335)
2 = Position display inhibited, otherwise same as 1 CN 123 4-246
MP7220 Block number step size for ISO programs
Input range: 0 to 255 CN 123 4-132
MP7222 Programming language selection: dialog or ISO
Input: 0 to 2
0 = Selection via MOD
1 = Only dialog
2 = Only ISO CN 123 4-132
MP7225 Generating blocks with the "ACTUAL POSITION
CAPTURE" key (not in ISO programming)
Input: 0 to 3
0 = no block generation possible
1 = block generation with the "ACTUAL POSITION
CAPTURE" key
2 = block generation with M2829 4-121
MP7230 Switching the dialogue language
Input: 0 or 1
0 = First dialog language
1 = Basic language (English) CN 123 4-134
MP7235 Resetting the timing
Input: 0 to 4
0 = No resetting
1 = Reset switch-on duration
2 = Reset run time of automatic operation
4 = Reset run time of spindle 4-118
MP7240 Inhibit program input for [Program name] = [OEM
cycle number in EPROM].
Input: 0 or 1
0 = Inhibited
1 = Not inhibited
9-5
MP7245.0 Inhibit the HEIDENHAIN cycles 1 to 15
Input range: 0 to 65 534 4-126
MP7245.1 Inhibit the HEIDENHAIN standard cycles
16 to 30
Input range: 0 to 65 535 4-127
MP7250 Difference between Q parameter number for "CALL-
active" and "DEF-active" block in OEM cycles
Input 0 to 50 9-5
MP7251 Number of global Q parameters that can be
transferred from OEM cycle to the calling program
Input: 0 to 100 9-5