HEIDENHAIN TNC 335 Technical Manual - Manual (Page 552)

8/95
TNC 360 6 Error messages 8-45
6.3 Data transmission software error messages
If data is transferred using the HEIDENHAIN - TNC.EXE data transmission program then the
following error messages might be displayed at the TNC:
DATA CARRIER @: IS FULL
Data carrier >@:< full.
FILE NAME NOT PROGRAM NAME
Name of NC program and name of file do not match.
INSTRUCTION NOT ALLOWED
Request instruction issued by control unit is not allowed.
PROGRAM INCOMPLETE
NC program does not contain an end block.
PROGRAM NOT PRESENT
File requested by control unit does not exist in currently configured access path.
PROTECTED FILE
File which is protected with read-only or hidden attribute is likely to be overwritten.
SEARCH FEATURE NOT ALLOWED
Search feature not included in number of acceptable characters.
TRANSFERRED DATA INCORRECT
Attempts to transmit block to control unit has failed four times.
TRANSFERRED DATA INCORRECT N
There was no acknowledgment ACK within a defined time
A precise description of this software is given in the User's Manual of the transmission software.