HEIDENHAIN TNC 335 Technical Manual - Manual (Page 544)

8/95
TNC 360 4 Data transfer with BCC 8-37
4.1.2 Outputting a selected program
The following protocol is followed:
Peripheral unit
.
.
.
Transmission path TNC
1st line of file BCC
Last line of file BCC
.
.
.
Name BCC
.
.
.
The program name may contain up to eight characters.
4.1.3 Outputting all programs
The files are output in order, as in Section 4.1.2 "Outputting a selected program". Control characters
are sent to the peripheral device between files.