HEIDENHAIN TNC 335 Technical Manual - Manual (Page 361)

4/96
TNC 360 3 List of Machine Parameters 5-17
3.10 Tapping
Machine
parameter Function and input Reaction /
CN 123 Page
MP7000 Acknowledgment of display "Power interruption"
0 = manual with "CE"
1 = automatic after 3 sec (for positioning module) –
MP7110.0 Minimum for feed override when tapping
Input range: 0 to 150 [%]
4-100
MP7110.1 Maximum for feed override when tapping
Input range: 0 to 150 [%]
4-100
MP7120.0 Dwell time for change of direction of spindle
rotation
Input range: 0 to 65.535 [s] 4-100
Advanced switch time of spindle for "tapping" cycle
(only active with BCD output of spindle rpm)
Input range: 0 to 65.535 [s]
4-102
MP7120.2 Spindle run-on time after reaching total hole depth
Input range: 0 to 65.535 [s]
4-100
MP7130 Spindle run-in characteristic
Input range: 0.001 to 10 [°/min]
(matching MP1520)
4-104
MP7140 Transient response of spindle on acceleration
Input range: 0.001 to 1
(matching MP1530)
4-104
MP7150 Positioning window for tool axis
Input range: 0.001 to 2 [mm]
4-104
MP7160 Suppress spindle orientation at the beginning of
Cycle 17
Input: 0 or 1
0 = Orient the spindle
1 = Suppress spindle orientation 4-104
3.11 Display and operation
Machine
parameter Function and input Reaction /
CN 123 Page
MP7210 Programming station
Input values: 0 to 2
0 = Control and programming
1 = Programming station, "PLC active"
2 = Programming station "PLC inactive"
CN 123
RESET 4-134