HEIDENHAIN TNC 335 Technical Manual - Manual (Page 310)

8/95
TNC 360 15 Tool Changer 4-213
M
→
S: Special tool follows Manual tool
With this toolchange sequence two pocket numbers (or tool numbers) must be transferred in
succession. M2093 indicates that another TOOL CALL strobe (M2046) follows.
Irrespective of marker M2600 and M2601, pocket number 255 and tool number 0 are transferred
first. Tool number 0 tells the PLC to clear the spindle. Pocket number 255 means that there is no
pocket in the tool magazine for the called tool. After acknowledging with M2483, the pocket number
and tool number of the new tool (called tool) are transferred.
0
0
0
0
0
0
0
0
3RFNHW1R3RFNHW1R>6@ :
7RRO1R7RRO1R>6@
: