HEIDENHAIN TNC 335 Technical Manual - Manual (Page 563)

10-2
TNC 360 1 PLC Positioning Module 8/95
1 PLC Positioning Module
1.1 Introduction
A hardware version of the LE 360 – the LE 234.003 – can be used in conjunction with the
TNC 407/TNC 415 as a positioning module.
In this way the TNC 407/TNC 415 can be expanded by up to 4 auxiliary axes. PLC inputs and outputs
of the LE 234.003 can also be used.
The positioning module can be used for controlling tool changers and pallet feed as well as rotary
axes and swivel heads.
The NC software of the TNC 360 can also be run on the LE 234.003, i.e. all the functions of the TNC
360 are also possible with the positioning module.
This Technical Manual is therefore also applicable to the LE 234.003.