HEIDENHAIN TNC 335 Technical Manual - Manual (Page 2)

8/95
TNC 360
Preface
This Technical Manual is intended for all manufacturers and distributors of machine tools. It
contains all the necessary information for the assembly, electrical installation, start-up and PLC
programming for the HEIDENHAIN contouring controls TNC 360.
Whenever HEIDENHAIN improves the hardware or software in these controls you will receive a free
delivery of updated information. Please arrange and insert this updated information in your manual
without delay. This will ensure that your manual always remains at the current revision level.
You can use extracts from this manual for your machine documentation. An enlargement of the
manual format (17 cm x 24 cm) by a factor of 1.225 will produce pages in A4 format.
No manual can be perfect. Like all living things it must grow and change. Among other things, it
lives from your impulses and suggestions for improvement. Please help us by giving us your ideas.
DR. JOHANNES HEIDENHAIN GmbH
Department E/P
PO Box 1260
83292 Traunreut
Germany