HEIDENHAIN TNC 335 Technical Manual - Manual (Page 558)

9-6
TNC 360 1 Introduction 8/95
1.2 Dialogues for OEM cycles
The dialogue numbers defined in the OEM-cycle determine the text to be displayed from the PLC
EPROM
The following dialogue texts for the designation of the OEM-cycle and the input parameters are files
in the standard PLC-EPROM.
Dialogue number in OEM-cycle Standard dialogue in PLC EPROM
0 USER CYCL
1 CYCL PARAMETER 01
2 CYCL PARAMETER 02
. .
. .
. .
99 CYCL PARAMETER 99
Instead of these standard dialogues up to 100 customized dialogues can be filed in the PLC-EPROM.
1.3 Output in binary code
If the OEM cycles have been fully tested, they can be output together with the PLC program in
binary form for EPROM programming. It is possible to output both the files located in the PLC
EPROM and those in the NC program memory in binary code. An accurate description of file output
via the data interface is given in Chapter "PLC-programming".