HEIDENHAIN TNC 335 Technical Manual - Manual (Page 33)

3-2
TNC 360 8/95
8 Touch Probe System Input 3-28
8.1 Connector assignment 3-28
8.2 Connection of the touch probe system 3-29
8.2.1 TS 120 3-29
8.2.2 TS 511 3-30
9 RS-232-C/V.24 Data Interface 3-32
10 Handwheel Input 3-33
10.1 Pin layout 3-33
10.2 Portable handwheel HR 330 3-33
10.3 Integral handwheel HR 130 3-34
10.4 Portable handwheel HR 332 3-35
10.5 HRA 110 handwheel adapter 3-37
11 PLC inputs/outputs 3-40
11.1 Technical data 3-40
11.2 Connector assignment 3-41
11.2.1 PLC inputs 3-41
11.2.2 PLC output 3-42
11.3 Connecting cable 3-43
11.4 PLC I/O expansion-board 3-45
11.4.1 PL 400 connection 3-45
11.4.2 PLC inputs/outputs on the PL 400 3-47
11.5 PL 410 PLC I/O expansion-board 3-49
11.5.1 PLC inputs/PLC outputs on the PL 410 3-50
12 Machine control panel 3-53
12.1 Pin layout 3-53
12.2 Connecting cable 3-54
13 TNC keyboard 3-56
13.1 Pin connections 3-56
13.2 Connecting cable 3-57
14 Dimensions 3-58
14.1 LE 360 C 3-58
14.2 Keyboard units 3-59
14.2.1 TE 355 A 3-59
14.2.2 TE 355 B 3-60
14.3 Visual display units 3-61
14.3.1 BE 212 3-61
14.3.2 BF 110 3-62