Configuring a zone member – H3C Technologies H3C SecPath F1000-E User Manual
Page 36
26
Figure 18 Zone list
2.
Click Add.
Figure 19 Creating a zone
3.
Configure the zone as described in
4.
Click Apply.
Table 7 Configuration items
Item Description
Zone ID
Set the zone ID.
Zone Name
Set the zone name.
Preference
Set the preference of a zone.
By default, packets from a high priority zone to a low priority zone are allowed to pass.
Share
Set whether the specified zone can be referenced by other virtual devices.
Configuring a zone member
1.
Select Device Management > Zone from the navigation tree.
2.
Click the
icon corresponding to the zone to be modified.
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS