H3C Technologies H3C SecPath F1000-E - Manual (Page 111)

101
2. Configure a static address mapping:
a. Select Firewall > NAT Policy > Static NAT from the navigation tree.
b. Click Add in the Static Address Mapping area.
c. Enter 1.1.1.1 for Internal IP Address.
d. Enter 2.2.2.3 for Global IP Address.
e. Click Apply.
Figure 99 Adding a static address mapping
3. Enable static NAT on GigabitEthernet 0/1:
a. Click Add in the Interface Static Translation area.
b. Select interface GigabitEthernet0/1.
c. Click Apply.
Figure 100 Enabling static NAT on an interface
4. Configure virtual fragment reassembly:
a. Select Firewall > Session Table > Advanced from the navigation tree.
b. Select Trust for Security Zone.
c. Select the Enable Virtual Fragment Reassembly box.
d. Click Apply.