H3C Technologies H3C SecPath F1000-E - Manual (Page 230)

220
Figure 161 Adding a user for device management
Configuring the RADIUS server on IMC PLAT 5.0
This section uses IMC PLAT 5.0 (E0101H03) and IMC UAM 5.0 SP1 (E0101P03).
1. Add an access device:
a. Log in to IMC, click the Service tab, and then select User Access Manager > Access Device
Management > Access Device from the navigation tree.
b. Click Add to configure an access device as follows:
Set the shared key for authentication and accounting to expert.
Set the ports for authentication and accounting to 1812 and 1813, respectively.
Select Device Management Service as the service type.
Select H3C(General) as the access device type.
Select the access device from the device list or manually add the device with the IP address of
10.1.1.2.
c. Click OK.
The IP address of the access device specified here must be the same as the source IP address of the
RADIUS packets sent from SecPath, which is chosen in this order:
{
IP address specified with the nas-ip command on the access device
{
IP address specified with the radius nas-ip command on the access device