H3C Technologies H3C SecPath F1000-E - Manual (Page 242)

232
Set the ports for authentication and accounting to 1812 and 1813, respectively.
Select LAN Access Service as the service type.
Select H3C as the access device type.
Select SecPath from the device list or manually add the device with the IP address of 10.1.1.2.
c. Click OK.
The IP address of the access device specified here must be the same as the source IP address of the
RADIUS packets sent from the access device, which is chosen in this order:
{
IP address specified with the nas-ip command on the access device
{
IP address specified with the radius nas-ip command on the access device
{
IP address of the outbound interface (the default)
Figure 172 Adding an access device
2. Add a charging plan:
a. Click the Service tab, and select Charging Service > Charging Plans from the navigation tree.
b. Click Add to configure a charging plan as follows:
Enter UserAcct as the plan name.
Select Flat rate as the charging template.
Select time for Charge Based on, select Monthly for Billing Term, and type 120 in the Fixed Fee
field.
Enter 120 in the Usage Threshold field and select hours for the in field to allow the user to
access the Internet for up to 120 hours per month.
c. Click OK.