H3C Technologies H3C SecPath F1000-E User Manual
Page 249
239
Enable or disable IP address reallocation. To use direct portal authentication, select No from
the Reallocate IP list.
c.
Leave the default settings for other parameters and click OK.
Figure 182 Adding a portal device
4.
Associate the portal device with the IP address group:
a.
In the portal device list, click the Port Group Information Management icon for device NAS.
Figure 183 Device list
b.
Click Add to configure a port group as follows:
Enter the port group name group.
Select Portal_user from the IP Group list. The IP address used by the user to access the network
must be within this IP address group.
c.
Leave the default settings for other parameters and click OK.
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS