H3C Technologies H3C SecPath F1000-E - Manual (Page 228)

218
Enter username hello@bbb and set the password.
Select Telnet as the service type.
Set the EXEC privilege level to 3. This value identifies the privilege level of the Telnet user after
login, which is 0 by default.
Specify IP addresses 192.168.1.0 to 192.168.1.255 as the range of hosts to be managed.
c. Click OK.
Figure 159 Adding a user for device management
Configuring the RADIUS server on IMC PLAT 3.20
This section uses IMC PLAT 3.20-R2606 and IMC UAM 3.60-E6206.
1. Add an access device:
a. Log in IMC, click the Service tab, and then select Access Service > Access Device from the
navigation tree.
b. Click Add to configure an access device as follows:
Set the shared keys for authenticating authentication and accounting packets to expert.
Specify the ports for authentication and accounting as 1812 and 1813, respectively.
Select Device Management Service as the service type.
Select H3C as the access device type.
Select the access device from the device list or manually add the device with the IP address of
10.1.1.2.
c. Click OK.
NOTE:
The IP address of the access device specified above must be the same as the source IP address of the
RADIUS packets sent from SecPath, which is the IP address of the outbound interface for RADIUS packets
(the default), or the IP address specified with the nas-ip or radius nas-ip command.