H3C Technologies H3C SecPath F1000-E - Manual (Page 188)

178
Figure 145 Adding an access device
The IP address of the access device must be the same as the source IP address of the RADIUS
packets sent from SecPath. By default, the source IP address of a RADIUS packet is the IP address
of the interface through which the packet is sent out.
2. Add a user account for device management:
a. Click the User tab, and then select Access User View > All Access Users from the navigation
tree.
b. Click Add to configure a user account for device management as follows:
Enter hello@bbb as the account name.
Set the password to abc and confirm the password.
Select Telnet as the service type.
Set the EXEC privilege level to 3. This value identifies the privilege level of the Telnet user after
login, which is 0 by default.
Click Add in the IP Address List of Managed Devices area to add IP addresses 10.1.1.0 to
10.1.1.255 as the range of hosts to be managed. The address range must contain the IP
address of the access device added in the previous step.
c. Click OK.