H3C Technologies H3C SecPath F1000-E - Manual (Page 140)

130
Figure 116 Device list
On the port group configuration page, click Add to enter the page for adding a port group, as shown
in
Figure 117 . Perform the following configurations:
• Enter the port group name.
• Select the configured IP address group. The IP address used by the user to access the network must
be within this IP address group.
• Use the default settings for other parameters.
Figure 117 Port group configuration
# Select Service Parameters > Validate System Configuration from the navigation tree to validate the
configurations.
Configuring the SecPath
1. Configure a RADIUS scheme:
# Create a RADIUS scheme named rs1 and enter its view.
system-view
[SecPath] radius scheme rs1
# Set the server type for the RADIUS scheme. When using the CAMS or IMC server, set the server
type to extended.
[SecPath-radius-rs1] server-type extended
# Specify the primary authentication server and primary accounting server, and configure the keys
for communication with the servers.
[SecPath-radius-rs1] primary authentication 192.168.0.112
[SecPath-radius-rs1] primary accounting 192.168.0.112
[SecPath-radius-rs1] key authentication radius