H3C Technologies H3C SecPath F1000-E - Manual (Page 187)

177
Enter hello@bbb as the user name.
Set the password to abc and confirm the password.
Select Telnet as the service type.
Set the EXEC privilege level to 3. This value identifies the privilege level of the Telnet user after
login, which is 0 by default.
Specify the IP address range of the hosts to be managed as 192.168.1.0 to 192.168.1.255,
and then click Add to add the address range to the list.
c. Click OK.
Figure 144 Adding an account for device management
Configuring the RADIUS server running on IMC
This example assumes that the RADIUS server runs on IMC PLAT 3.20-R2602 and IMC UAM
3.60-E6102.
1. Add SecPath to IMC as an access device:
a. Log in to IMC, click the Service tab, and then select Access Service > Service Configuration
from the navigation tree.
b. Click Add to configure an access device as follows:
Set the shared key for authentication and accounting packets to expert.
Specify the ports for authentication and accounting as 1812 and 1813, respectively.
Select Device Management Service as the service type.
Select H3C as the access device type.
Select SecPath from the device list or manually add it with the IP address of 10.1.1.2.
c. Click OK.