H3C Technologies H3C SecPath F1000-E - Manual (Page 248)

238
Figure 180 Portal server configuration
2. Configure the IP address group:
a. Select Access Service > Portal Service Management > IP Group from the navigation tree.
b. Click Add to configure an IP address group as follows:
Enter Portal_user as the IP group name.
Set the start IP address to 192.168.1.1 and the end IP address to 192.168.1.255. The IP
address of the host must be within this IP address group.
Select No for Enable NAT.
c. Click OK.
Figure 181 Adding an IP address group
3. Add a portal device:
a. Select Access Service > Portal Service Management > Device from the navigation tree.
b. Click Add to configure a portal device as follow:
Enter NAS as the device name.
Enter the IP address of the access interface on the firewall, which is 192.168.1.70.
Enter the key, which is portal, the same as that configured on SecPath.