H3C Technologies H3C SecPath F1000-E User Manual
Page 251
241
Figure 185 Portal server configuration
2.
Configure the IP address group:
a.
Select User Access Manager > Portal Service Management > IP Group from the navigation
tree.
b.
Click Add to configure an IP address group as follows:
Enter Portal_user as the IP group name.
Set the start IP address to 192.168.1.1 and the end IP address to 192.168.1.255. The IP
address of the host must be within this IP address group.
Select Normal from the Action list.
c.
Click OK.
Figure 186 Adding an IP address group
3.
Add a portal device:
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS