Verilink 8100A (34-00237) Product Manual - Manual (Page 98)

4-24 8 0 0 0 S e r i e s
Figure 4.33 Current Configuration Table
3 Type “1” to select a channel range for voice as shown in Figure 4.34.
Figure 4.34 Configure Voice Channels
4 Type “2” on the T1/E1 Channel Configuration menu (Figure 4.33) to
select the signaling protocol for voice channels.
Figure 4.35 Select Signaling Protocol for Voice Channels
5 Type “3” on the T1/E1 Channel Configuration menu (Figure 4.33) to
select a channel range for data channels. You will see a screen similar to
that shown in Figure 4.34.
6 Type “4” on the T1/E1 Channel Configuration menu (Figure 4.33) to
select the datalink protocol for the data channels.
Configure ATM PVCs
You may configure up to eight ATM PVCs on the IAD. Remember always to
reset the IAD to make PVCs active.