Enable/disable nat debug messages, Enable/disable nat debug messages -102 – Verilink 8100A (34-00237) Product Manual User Manual
Page 176

4-102
8 0 0 0 S e r i e s
Figure 4.113
NAT Configuration Menu
You may sign on as Supervisor or Network Manager to configure NAT.
Options that display in the NAT Configuration menu depend on your security
level. The menus shown are at the Supervisor security level.
NOTICE:
You must reset the IAD when you have finished making changes to NAT
configuration for configuration changes to take effect.
The table below lists the default NAT settings.
A significant advantage of NAT is that you can configure it without changing
hosts or routers, other than those few routers on which NAT is configured.
NAT multiplexes internal network traffic and presents it to the Internet as if it
is from a single source with one IP address.
Enable/Disable NAT Debug Messages
To obtain diagnostic debug output during NAT operations, you may enable
NAT Debug Messages. Type “B” on the NAT Configuration menu, then type
“E”
to enable or “D” to disable.
Parameter
Range
Default
NAT Translation by Port
Enabled | Disabled
Disabled
NAT TCP Timeout
60 to 3600 seconds
300 seconds
NAT UDP Timeout
60 to 3600 seconds
120 seconds
NAT port range
− low end
5000 to 65534
5000
NAT port range
− high end
50000 to 65535
65535
- 8108 Series IAD (34-00339.B) Product Manual 8508 Series IAD (34-00339.B) Product Manual 8208 Series IAD (34-00339.B) Product Manual 8308 Series IAD (34-00339.B) Product Manual 7500p Series IAD (34-00334.B) Product Manual 7200p Series IAD (34-00334.B) Product Manual 7000 Series (34-00334) Product Manual