Verilink 8100A (34-00237) Product Manual - Manual (Page 58)

3-8 8 0 0 0 S e r i e s
1 Type “P” on the SNMP Configuration menu to configure system contact
(up to 39 alphanumeric characters). The IAD displays the current system
contact and prompts you to enter a new one.
2 Type the name of the new contact person or department and press Enter.
The IAD save the configuration.
3 Continue with other SNMP settings, or press Escape to return to the Main
menu.
4 Reset the IAD.
Configure System Name
To configure the System Name, follow the steps below.
1 Type “N” on the SNMP Configuration menu to configure the system name
(up to 39 alphanumeric characters). The IAD displays the current system
name and prompts you to enter a new one.
2 Type the new system name and press Enter. The IAD saves the
configuration.
3 Continue with other SNMP settings, or press Escape to return to the Main
menu.
4 Reset the IAD.
Configure System Location
To configure the System Location, follow the steps below.
1 Type “L” on the SNMP Configuration menu to configure the system
location (up to 39 alphanumeric characters). The IAD displays the current
system location and prompts you to enter a new one.
2 Type the name of the new server location and press Enter. The IAD saves
the configuration.
3 Continue with other SNMP settings, or press Escape to return to the Main
menu.
4 Reset the IAD.
Configure SNMP Community
The value you set must match the write community name of the SNMP host
to enable the SNMP Set operation. If you enable SNMP and the read-write
Community Name is null, SNMP enters read-only mode with a community
name of “public.”
1 Type “L” on the SNMP Configuration menu to select Configure System
Location. The IAD displays the current community name and prompts you
to enter a new one.
2 Type the name of the SNMP community to which your system belongs and
press Enter. The IAD saves the configuration.