Verilink 8100A (34-00237) Product Manual - Manual (Page 68)

3-18 8 0 0 0 S e r i e s
Figure 3.9 Time Menu
NTP Server Menu
Type “S” on the Time menu to bring up the NTP Server menu.
Figure 3.10 NTP Server Menu
To configure the NTP Server Timeout period, type “T” on the NTP Server
menu. The IAD displays the current timeout period and prompts for a new
value.
To configure a Primary NTP Server, type “P” on the NTP Server menu and
enter the IP address or the host name if DNS Client is configured. When you
configure a Primary NTP Server, the IAD displays the Primary and Secondary
NTP servers instead of the default ‘Country NTP Server.’
You may configure a Secondary NTP Server as a backup in case the Primary
NTP Server cannot be contacted. Type “S” on the NTP Server menu and
enter the IP address or the host name if DNS Client is configured.
To remove the configuration of Primary and Secondary NTP Servers, type
“C”
on the NTP Server menu.
Time Zone Menu
The Time Zone menu (Figure 3.9Figure 3.9) is used to help set the current
time. When the IAD is reset or the power is cycled, the IAD will use Network
Timing Protocol (NTP) to obtain the current time.