Verilink 8100A (34-00237) Product Manual User Manual
Page 229

C o m m a n d L i n e I n t e r f a c e
6-9
set mgcp nat (off|on) [
off | on
Keyword to disable (off) or enable (on) MGCP keep-alive traffic.
set mgcp notified entity
Sets entities for MGCP to notify of events such as on-hook and off-hook.
set mgcp notified entity (
[<1-4>]
domain-name
Web address such as www.verilink.com. This format is only allowed for
notified entity number 1.
ip-address
IP address in decimal format (999.999.999.999).
set mgcp
signaling port
Specifies the UDP port the IAD uses for incoming MGCP messages.
set mgcp signaling port
port
UDP Port number (any valid port number; usually 2427).
set nat alias add
Lets the user add a NAT alias. Each NAT alias entry allows a device on the
LAN (inside of NAT) to be accessible from the Internet via a unique IP
address. The IAD only translates IP addresses for alias entries
− port numbers
are not changed.
set nat alias add
index
Index used on the NAT alias table.
local-ip-address
Local IP address.
network-ip-address
Network IP address.
set nat alias
remove
Lets the user remove a NAT alias.
set nat alias remove
index
Index used on the NAT alias table.
set nat enable
Enables or disables NAT on the specified port. If you do not enter any
optional parameters, it finds the first available slot, interface and port.
set nat enable (off|on) [
[
off | on
Keyword to disable (off) or enable (on) NAT on the specified port.
- 8108 Series IAD (34-00339.B) Product Manual 8508 Series IAD (34-00339.B) Product Manual 8208 Series IAD (34-00339.B) Product Manual 8308 Series IAD (34-00339.B) Product Manual 7500p Series IAD (34-00334.B) Product Manual 7200p Series IAD (34-00334.B) Product Manual 7000 Series (34-00334) Product Manual