Set country mode, Set duslic mode, Enable/disable g726 annex a – Verilink 8100A (34-00237) Product Manual User Manual
Page 159: Interworking connections, Interworking connections -85

C o n f i g u r a t i o n
4-85
NOTICE:
Normally, u-Law is used in North America and a-Law is used in
Europe.
Set Country Mode
Figure 4.100
Country Mode Selection Menu
Set DuSLIC Mode
To set DuSLIC Mode (for POTS only), follow the steps below. (The
following are configured when a Country Mode is selected.)
1
Type “T” on the Voice Configuration menu (Figure 4.70) to display the
DuSLIC Mode Selection menu.
Figure 4.101
DuSLIC Mode Selection Menu
2
Type the option of the control mode to set. The IAD saves the mode you’ve
selected and redisplays the menu.
3
Press Escape to return to the Voice Configuration menu and continue with
other voice path configuration.
Enable/Disable G726 Annex A
Type “G” on the Voice Configuration menu (Figure 4.70) to enable/disable
G726 Annex A.
Interworking Connections
To communicate over WANs, end-user stations and the network cloud have typ-
ically been required to use the same type of transmission protocol. This limita-
tion has prevented different network protocols such as Frame Relay and ATM
- 8108 Series IAD (34-00339.B) Product Manual 8508 Series IAD (34-00339.B) Product Manual 8208 Series IAD (34-00339.B) Product Manual 8308 Series IAD (34-00339.B) Product Manual 7500p Series IAD (34-00334.B) Product Manual 7200p Series IAD (34-00334.B) Product Manual 7000 Series (34-00334) Product Manual