Verilink 8100A (34-00237) Product Manual - Manual (Page 126)

4-52 8 0 0 0 S e r i e s
Configure Host Name
To configure the Host Name, follow the steps below:
1 On the Router Configuration menu (Figure 4.59), type “I”.
2 The IAD displays the current Host Name and prompts you to enter a new
one.
3 Continue with other configuration tasks, or press Escape to return to the
Main menu.
Remove Host and Domain Names
To remove the Host and Domain Names, type “J” on the Router
Configuration menu (Figure 4.59).
Display Route Table
To display the Route table and view information about statically configured
routes and dynamically learned ones, type “D” on the Router Configuration
menu (Figure 4.59).
The IAD displays each network address and related information:
Route Table parameters are described in the following table.
Parameter Description
Network Destination network destination address
Netmask IP subnet mask; number of bits reserved for the
host ID
Gateway Address IP address of packets sent to destination
Interface IP address of outgoing interface
Metric number of hops (routers) required to reach the
specified gateway
Type static | dynamic | RIP | local