Verilink 8100A (34-00237) Product Manual - Manual (Page 149)

C o n f i g u r a t i o n 4-75
If MGCP configuration is not correct, the IAD displays a message warning
you that the configuration is invalid and initialization is incomplete.
Debug MGCP The use of this option is reserved for Verilink network engineers only.
Enabling debug options may significantly affect IAD performance.
Remove a Connection 1 Type “R” on the MGCP Management menu (Figure 4.88) to remove a lost
connection.
2 Type the number of the Connection ID to delete and press Enter.
Port Administration Type “A” on the MGCP Management menu to (Figure 4.88) to display the
Port Administration menu (Figure 4.90).
Figure 4.90 Port Administration Menu
NOTICE: These options are only available when you log in at the Network
Administrator or Supervisor levels.
Set Admin State for All Ports
1 Type “1” on the Port Administration menu (Figure 4.90) to enable or
disable the admin state for all ports.
2 Type “E” to enable the admin state, or “D” to disable it. The IAD saves the
mode you’ve selected and redisplays the Port Administration menu.
3 Press Escape to return to the Voice Configuration menu and continue with
other voice path configuration.
Display Current Admin State
To display the Current Admin State, follow the steps below.
1 Type “2” on the Port Administration menu (Figure 4.90) to display the
current admin state by port number. The IAD displays the report:
2 Press any key to return to the Port Administration menu.
Configure Admin State per Port
To configure the Admin State per port, follow the steps below.
1 Type “3” on the Port Administration menu (Figure 4.90) to enable or
disable the admin state for a specific port. The IAD prompts you to enter a
port.